The post Angle Thermostatic Radiator Valve – Pex-B appeared first on Valve, Flex Hose, PPR Pipe.

The post Thermostatic Radiator Valve Set – (Angle Type) appeared first on Valve, Flex Hose, PPR Pipe.

ANGLE THERMOSTATIC RADIATOR VALVE – PVC

PEX-B ANGLE THERMOSTATIC RADIATOR VALVE – PVC

INSTALLATION and OPERATING INSTRUCTION

1- Make sure there is no damage on the product may occur during transport and shipping. Before assembly do not unpack
the product in order to prevent from the external effects.
2- Clean all kinds of contaminants before assembly.
3- Make sure that the thread length to be connected to the valve is not too short or too long than the thread length of the
valve.
4- Keep the valve in closed position during installation. Install the valve with the appropriate tool from the side where you’ll
mount it.
5- Use enough flax or plumping adhesive.
6- Do not paint the valve, do not expose the valve with abrasive chemicals,
7- Do not open or close with any other tool.
8- Pay attention to on header signs by taking into account heat requirement while use valve.
9- The boiler temperature must be higher than the temperature of the thermostat that is set; otherwise, if the circulation
pump is switched on, the flow sound hear from valve.
10- Set cursor to Max. grade at regular intervals and tighten connection nut to fix the gap.
11- The cap should be set to Max. grade during the summer months.
12- The cap should be set to (*) this position during the winter months.
13- (O) does not indicate close position. Not bring to this position during the winter months .
14- Use filter in the installation to keep cleanly to apartment entrance
15- Do not hang anything on the cap.
16- The pressure balancing valves should be used in floor entrance to supply quiet working and prevent uneven flow of
thermostatic radiator valve.
17- To supply quiet working, the maximum pressure changing must not exceed 30-35 kPa.

The post Angle Thermostatic Radiator Valve – PVC appeared first on Valve, Flex Hose, PPR Pipe.

The post Angle Thermostatic Radiator Valve With Bilist appeared first on Valve, Flex Hose, PPR Pipe.

The post Angle Thermostatic Radiator Valve With Bilist – Pex-B appeared first on Valve, Flex Hose, PPR Pipe.

The post Angle Thermostatic Radiator Valve – Jack appeared first on Valve, Flex Hose, PPR Pipe.

Compact Thermostatic Insert Installation and Operating Instruction

1- Make sure there is no damage on the product may occur during transport and shipping. Before assembly do not unpack the product in order to prevent from the external effects.
2- Clean all kinds of contaminants before assembly.
3- Make sure that the thread to be connected to the insert is suitable.
4- Install the insert with the appropriate tool from the hexagon side.
5- Do not paint the insert, do not expose the insert with abrasive chemicals.
6- Do not open or close with any other tool.
7- The flow ranges for presetting can be set simply with appropriate tool that will not make deformation.
8- Only experienced technicians are permitted to adjust the flow ranges.
9- The selected value can be read off over the insert.

The post Thermostatic Insert appeared first on Valve, Flex Hose, PPR Pipe.

The post Angle Thermostatic Radiator Valve appeared first on Valve, Flex Hose, PPR Pipe.

The post Axial Thermostatic Radiator Valve appeared first on Valve, Flex Hose, PPR Pipe.

The post Straight Thermostatic Radiator Valve appeared first on Valve, Flex Hose, PPR Pipe.